Saturday, February 26, 2022

When all else fails...format & reinstall

After getting the shack computer up and running, I was happily chugging along.  I was installing all the software that I used on the Pi and got finished in decent time.   Not a bad night in the shack, as lots of progress was made.   

Until I decided to install just one more piece of software that I'd not used in a Linux environment before.

Again, I'm comfortable in a Linux environment, but I'm no expert by any means.   Anyway, I start to install one of the pieces of software that I use on my windows laptop to generate CNC code from Gerber files.  I'm aware that there are dependencies for certain software, so I check the dependency list and go out and start gathering all the required packages and files.  

You would have thought that I threw a tire-iron into the wheel-spokes.   Of course, mistakes were made, and in the course of removing and reinstalling software packages, I managed to botch the entire OS install.
Now, I'm sure that I can fix it.  But I also know how much time it has taken me to get to this point.   What I do NOT know, is how long it will take me to find the problem (a.k.a. how I screwed it up) nor how long it will take me to fix it.  

So, I did what I thought would save me the most time, overall.    I started over from scratch and performed a complete re-install of the OS again.

Hindsight, I lost a day in the shack due to my own mistakes.  I guess I should just leave "good enough" alone and keep chugging along!

73s

Jason

No comments:

Post a Comment

It BREATHES!

With the antenna amplifier sorted and installed on the board.  I couldn't wait and I held my breath as I connected the antenna input to ...