Friday, February 25, 2022

No need to swear, but did you try to reboot?

My beloved shack computer, a Raspberry Pi 4 has apparently decided that it was finished being the shack-duty, CNC controlling, schematic displaying, gateway to knowledge that it was.   I got into the shack last night and the Pi wouldn't boot.  nothing but a black screen.  So I performed the obvious steps, rebooting, pulling and reseating power plugs, etc, etc, etc.  Still, no dice.   The Pi has become scraps for the compost bin (not really, I'll fix it over the next few days if its fixable and find another use for it.)

Rather than take the time to troubleshoot a hard drive failure (yes, my Pi has an SSD and boots from it, rather than the SD Card) I decided... since I had inherited a decent computer from my grandmother, I'd put it to good use in the shack.    So, the majority of my shack time was spend cleaning the workbench, taking the Pi out, and reconfiguring the bench with a bigger monitor and making space on the floor for the main case.   Needless to say, this is not amateur radio, but is a necessary evil nonetheless.

The Pi had long been my shack companion, and I'm quite familiar with running Linux in a desktop environment.  I wanted to continue that with the new PC from my grandma.  Plus, her old Windows install with all the software that she used wouldn't really do me much good.  I had saved all files and pictures on it shortly after inheriting it.  So, there was no harm in me wiping the drive with a fresh install of Ubuntu.

I loaded the requisite ISO file on to the thumb-drive, plugged it in, booted, and installed.  The install went very smoothly as expected.   I didn't really experience any issues until I had to load Candle, the software that I use for sending G-Code to my CNC router.   Apparently, it isn't compatible with and x86-64 operating system.   No worries...I asked the Oracle what she she though and was soon guided to a well written how-to and got it working in short order.  After spending the remainder of the evening configuring the computer as a shack-machine (setting up shared drives, installing my browser-of-choice, PDF viewers, Arduino IDE, enjoying a beverage, etc, etc, etc).  I then went on restoring my files that were on the Pi from the network-backup on my home server. (Note to the uninitiated:  routine backups are a life-saver and keep you from losing your mind when you lose your computer.)   

When all that was done, I fired up the CNC, loaded up Candle, and made sure that the movement of all the axes and spindles were still working.   When all that was done, my kids came in to say goodnight and I had just sat the new VFO board on the bench.  They asked a few questions and wanted to see the output of the SI-5351 on the oscilloscope.  I had to oblige, as anything less would be... uncivilized.

Anyway, I hope to get back into the shack this evening and see what I can conjure up.  I still need to install and configure some more software, the less-often used stuff.  And, I need to get my 3D printer out of storage and back on line since moving a couple years ago.  Maybe I'll get a chance to do some listening on the HF bands.  Maybe.

73's

Jason

No comments:

Post a Comment

It BREATHES!

With the antenna amplifier sorted and installed on the board.  I couldn't wait and I held my breath as I connected the antenna input to ...