With the antenna amplifier sorted and installed on the board. I couldn't wait and I held my breath as I connected the antenna input to it.
The chain is as follows: Antenna Amp - > SBL-1 -> Audio Amp> with CLK0 of the SI-5351 dumping into the LO port on the SBL-1.
Like clockwork, I couldn't hear anything. Adjusting the volume knob doesn't help, at all. Ok, maybe the signal is still too weak at the antenna amplifier. I hooked up the signal generator, injected a 10-milliVolt signal and that sweet, sweet sound of a 1KHZ (roughly) tone popped up into my ears. It wasn't very loud, but its there. =)
I've got some sorting to do with the audio amplifier. I may have to scrap & rebuild it, as, it's got a LOT of noise, the volume adjust doesn't work quite right, and its not quite loud enough. It could be the speaker, but I'm going to start with the audio amp first. Just in case, I ordered a pack of 10 pre-build audio amps from Bezos & Crew, and they should be here on Friday.
Update: I got it working using the previous LM380 Audio Amplifier. I scrapped the LM386 board, and fiddled with the LM380 one until I got it working good. =)
But I did fiddle with it, reconnected the antenna, and tuned down to the FT-8 portion of the band, and I could hear faint signals of the famed FT-8 "warble", so it does work. But I had a broadcast station coming in on it as well. I'm not sure if its from the length of cable that I have attached to the speaker, or if its something else with my configuration. I slapped together a LPF from the uBitX schematic, threw it in the input before the antenna amplifier, and it didn't fix the problem. Oh well, at least I have it built for when I do need it. =)
So it looks like I've got a few issues to noodle around on before I can proceed, but for now, it does work as a direct-conversion receiver...just not very well. =)
Update #2: It works pretty well with a working audio amplifier. =)
73s,
-Jason
No comments:
Post a Comment