Saturday, March 5, 2022

The Flux Capacitor is missing...or maybe some clueless amateur hooked it up backwards

Well, not really.  Today was a bit of a success!  I built a half-stage of the W7ZOI/K3NHI Termination Insensitive Amplifier as an Antenna Amplifier.   Mainly because I was feeling too lazy to wind impedance matching coils.   Ha!  The CNC process went fine, except for when I didn't load the G-Code for drilling after doing the isolation routing.   You can see that mistake in the bottom left corner. Luckily, I caught it before it continued to route the board with a 2.5mm drill bit...and did not ruin the board.


Once that was done, I soldered all the components in place.  (Which reminds me, I need to order more 15-ohm and 180-ohm resistors!)  Hooked it all up, and of course, it didn't work.   But where would the fun be in that?   I started the usual troubleshooting, visual, power, signal, etc.   Power was fine, input signal was fine, but didn't seem right.   Also, I wound up replacing all the electrolytics with 100nF Tantalums, because...reasons.  Anyway, after about 20 minutes, I gave up and went to cook dinner for the family.  Then, watched a couple episodes of the SWMBO's current favorite sitcom with her, before heading up to the shack around midnight.  I'd had some time to noodle this over in my brain, and I think something was wrong with the layout.  Of course, it has to be me...


I finally figured it out after going back over the schematic.  It'd routed and placed the trace for the 10K-ohm resistor to the wrong pad.   Oh well, its homebrew, so I can fix it.  I left that trace alone, instead opting to route the 10-ohm power resistor to a different pad, as that was the easier fix at the time.   Bam!  it worked.


If you look closely, you'll see that a 50 milli-Volt peak-to-peak input signal  (purple trace) becomes a 1.62 Volt peak-to-peak output (yellow trace) signal.   I'm not a mathmagician, but sources on google tell me that's around 29dB of gain.  I'll take it for now.  =)

Tomorrow, I'm going to re-flash the Arduino and increase the drive of the SI5351 chip feeding the SBL-1 mixers. 

73s, 

-Jason

No comments:

Post a Comment

It BREATHES!

With the antenna amplifier sorted and installed on the board.  I couldn't wait and I held my breath as I connected the antenna input to ...