Tuesday, March 1, 2022

Success! Time to move on..

 After 3 whole days burned on trying to get the CNC settings dialed in, I went into the shack yesterday with a newfound understanding of my past mistakes.   (Except that time with tequila in 2002...I don't much remember that one.)

I applied the new mathemagical properties that I'd discovered to my cutter diameter, generated new G-Code, and fired up the machine.   I probed the PCB to get a height-map, then nervously clicked the "send" button.   18 minutes later I was presented with as pristine of a board that could be made by a clueless amateur.  I still need to tweak some of the overlap settings, but overall, it turned out really good.  


Instead of immediately soldering the SBL-1 onto the breakout board like the last one, I took a hint from Chuck Adams and sprayed a thin coat of clear acrylic on it.  I'll solder it up in the next day or so, as it'll only take a few minutes.   If I don't forget, I'll post pics of the shiny-board before soldering it up.

Update:  Here's the main board with both SBL-1 mixers soldered to it.



Next step:  Audio Amplifier.

I spent a few minutes in the evening breadboarding an audio amp based on the LM380 from Charlie Morris. I was able to get it to make sounds with my cheap Ebay signal generator, but with an 8-ohm speaker attached, I couldn't get any real "volume" out of it no matter what I did with the input level, trim resistor adjustment, etc.  Plus, it seems like it distorts quite easily.  

Instead of that route, I think I'm going to build this audio amplifier based on an NE5532/LM386 from Vasily Ivanenko over at QRP Popcorn.    You can tell that Vasily spent a lot of time tweaking and testing, and there's no reason for me to doubt him (he's got Jazz Guitar ears).


I have a roll of 100 NE5532s, and haven't figured out what else to do with them at this point.   I'll build it on a breadboard and do some testing before I do the layout/milling/soldering. 

After the audio is finished, I'll probably tweak some settings in the Arduino code and determine what band I want this receiver to operator on for now.   Once I figure that out, I'll probably make up a band-pass filter to clean up the signals a little, which might require an antenna amplifier.  I'm not sure yet, I'll have to noodle on it for a little while.

73s,

-Jason

No comments:

Post a Comment

It BREATHES!

With the antenna amplifier sorted and installed on the board.  I couldn't wait and I held my breath as I connected the antenna input to ...