Monday, February 28, 2022

Well, there's your problem...



Have you ever watched someone do something stupid?   Then sometime in the future you wind up doing the exact same stupid thing, only to laugh at yourself just as hard as you laughed at the first-person being stupid?

Well.  That's me.   And this is why I'm stupid.  On another note, I may have found out why my cuts were so stinking crappy lately.

I was messing up so many circuit boards because I was using the wrong diameter cutter.   No, not making too deep of a cut, rather... I programmed the CNC wrong.    I was using a 30-degree Vee bit, with a cutting tip of 0.1mm.    So, my depth of cut was set at 0.1mm.   (Because I figured .1mm going down .1mm would leave a .1mm cut...)   Wrong!  I failed to add in the taper of the bit....30 degrees.

Luckily, FlatCam has a built-in calculator that I should have been using to calculate my "tool diameter".


So, instead of programming a .1mm diameter cutting tip, I should have been using a 0.1536mm diameter cutting tip.   The more I think about it, this would have a "broader" cutting edge when cutting through the copper of the PCB (the copper is higher up the bit) and the fine point only in the fiberglass.  I'll try a couple of boards tonight and see how it goes!

73s

-Jason

No comments:

Post a Comment

It BREATHES!

With the antenna amplifier sorted and installed on the board.  I couldn't wait and I held my breath as I connected the antenna input to ...