Sunday, February 27, 2022

Warning: Equipment should not be operated by Idiots


 Yep.   This one is all on Me. 

After getting a good night sleep and pondering my insufficiencies as a CNC operator, I awoke to a renewed sense of "I can do this."  After downing a cup of my favorite morning beverage (after all, us Vets are fueled by a love for coffee and a disdain for stupidity) I hit the computer and reprogrammed the CNC files to run.  I glued down a shiny-new piece of copper PCB material, probed the height-map, set the zeros, and started cutting.    All right!  The first set looks great!    Then it moves to the second cut, and I notice that the fiberglass isn't being cut, only the copper.   The bit isn't moving low enough to make it through the copper-clad material on top of the board.  

/insert Tazmanian Devil Sounds




(*@**!)(*$&&!)*(*)@#&&!(*&^^@#!@#*(^&!@#, !(@*&((!(*#^^!^!!!!!)

/end Tazmanian Devil Sounds

So, I junked another piece of copper, reprogrammed the CNC files to add another .025" of cutting depth, and tried again.  Maybe this is just me not cutting it deep enough.   IDK, but I was sure to find out.  

As luck would have it, I broke the tip off the bit.  So, once again, I fired up the G-Code software, and reprogrammed it to cut a single 30mm x 30mm board instead of a panel of 6 of them.   That way, it'll only take 28 minutes to cut one, instead of 2 hours.   Plus, I may waste a piece of copper, but at least I'll save the other spots on it for future cutting, resulting in less waste overall (I'd rather waste a 30mm x 30mm section than a 60mm x 90mm section).   I've prayed to the Radio Gods, bit I didn't have a chicken on-hand to sacrifice to Papa Legba.  Wish me luck.

73s,

-Jason

No comments:

Post a Comment

It BREATHES!

With the antenna amplifier sorted and installed on the board.  I couldn't wait and I held my breath as I connected the antenna input to ...